MicroNet Technology SP907BB Manuale Utente

User’s Manual Wireless LAN USB Adapter Model No.: SP907BB Website:http://www.micronet.info

9 Threshold, and Power Save function. 7. Profiles window: It provides customers to change settings and save them in the configuration file.

10 8. Info window: It shows the latest software version and MAC address.

11 4. Ad-Hoc (Peer to Peer) Mode Setup 4.1. Application 1Access the Internet without an AP With existing Internet conn

12 Setup Steps 1. Check the current environment and install WLAN cards i. Check whether “computer 1” connects to the Internet. ii. Install USB Wire

13 iii. Check the status of the Connection icon. Click the Connection icon, and you can see the device name and status under Network Connections. The

14 vi. Double click the WLAN icon in Icon Tray, and enter into the “Software and Utility window”. Software and Utility window: vii. Cha

15 Check whether the Setup is success Computer 1: 1. Enter into DOS MODE, and type “IPCONFIG”. (Start -> Run -> Type cmd or command) (in Win

16 2. Check whether the IP address is 192.168.0.1, and the Subnet Mask is 255.255.255.0 (as shown above) Computer 2: 1. IP address does not need to

17 5. Appendix 1. Operation Mode: SP9007BB has two modes, ‘Infrastructure’ and ‘Ad-Hoc’. The default setting is “Infrastructure”. (Please refer to the

18 10. Fragmentation Threshold: This configuration determines whether needs to fragment the Frame during transmit. When fragment, if the transmit fell

1 Content 1. Introduction...

2 1. Introduction Thank you for using Micronet SP907BB. This installation guide will help you ins

3 Ad-Hoc Mode Ad-Hoc mode is a Peer-to-Peer mode. Without an AP, computers can also connect to each other by SP907BB. With this

4 2. Installation Note: The screens showed below are from Windows 2000. For other Windows system, the steps a

5 4. Your PC will recognize the device of “USB Wireless LAN Card”, and click “Next” to install driver. 5. Finally, click the “Finish” to leave this

6 3. Software Installation 1. Insert the “Manual & Driver CD-ROM” into the CD-ROM driver of your PC,

7 3.1. Software Utility 1. Click the icon and the software utility window shows up. 2. Status window allows you to change Operation Mode, Channel,

8 current environment. Double click the device you want to connect. 5. Encryption window: SP907BB is able to provide 64/128Bit encryption. 6. A